DLP LightCrafter Display 2000 EVM on Raspberry Pi #piday #raspberrypi @Raspberry_Pi


NewImage

Thanks to Frederick for sending in this tip! Frederick writes:

Wrote a guide on how to get Texas Instruments’ DLP LightCrafter Display 2000 EVM pico projector for BeagleBone Black to work on the Raspberry Pi 3B+.

From Frederick Vandenbosch:

As part of element14’s RoadTest program, I recently got to review Texas Instruments’ DLP LightCrafter Display 2000 pico projector for BeagleBone Black. After finishing the review, I wasn’t satisfied with the performance of the BeagleBone Black, and decided to swap it out in favour of a Raspberry Pi 3B+.

Credits go to Philip Hodgers, whose post I found on TI’s E2E forum, for figuring out the wiring and config parameters to get the projector to work via the Pi’s DPI interface.

Read more!


3055 06Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!


via Adafruit

Thoughts or comments?