A few years ago, I rescued a pair of nice headphones from the trash and replaced the original speakers with better sounding Sennheisers.
Then, I changed the jack cable for something fancier (and I must admit, less practical).
Now, it is time to put the headphones on the operation table once again to cut the wires..
Because I wanted to keep the headphones as much in their original state as possible, without adding holes, I decided to use the original potentiometer for control and volume. This means I had to find a way to detect a press on the potentiometer. For the bluetooth part I will use the Microchip BM62 Bluetooth module. It’s really cheap and has everything already built-in (Bluetooth LE, a serial interface for control, pins for LEDs, a battery charger and an audio amplifier).
Every Wednesday is Wearable Wednesday here at Adafruit! We’re bringing you the blinkiest, most fashionable, innovative, and useful wearables from around the web and in our own original projects featuring our wearable Arduino-compatible platform, FLORA. Be sure to post up your wearables projects in the forums or send us a link and you might be featured here on Wearable Wednesday!